Inspection |
1. |
Measure terminal-to-terminal resistance of the blower resistor. |
2. |
measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)
|
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Disconnect the blower resistor connector (A) and then remove the blower resistor (B) after loosening the mounting screws. |
3. |
Installation is the reverse order of removal. |
Weight of the trailer tongue
The tongue load of any trailer is an important weight to measure because it affects
the total gross vehicle weight (GVW) of your vehicle. This weight includes the curb
weight of the vehicle, any ...
Rear Hub - Carrier: Repair procedures
Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque :
88.3 ~ 1 ...