Inspection |
1. |
Check the signal waveform of the CMPS and CKPS using the GDS.
|
Removal |
|
[Bank 1 / Intake] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the camshaft position sensor connector (A). |
3. |
Remove the installation bolt (B), and then remove the sensor. |
[Bank 1 / Exhaust] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the heater protect cover (Refer to "Intake And Exhaust System" in EM group). |
3. |
Disconnect the camshaft position sensor connector (A). |
4. |
Remove the hanger and the protector. |
5. |
Remove the installation bolt, and then remove the sensor. |
Installation |
|
|
|
|
1. |
Installation is reverse of removal.
|
Main components of the occupant detection system
A detection device located within the front passenger seat cushion.
An electronic system which determines whether the passenger air bag systems
should be activated or deactivated.
A indicato ...
Trailer towing
If you are considering towing with your vehicle, you should first check with
your country's Department of Motor Vehicles to determine their legal requirements.
Since laws vary the requirements ...