Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the CCV connector. |
3. |
Measure resistance between the CCV terminal 1 and 2. |
4. |
Check that the resistance is within the specification.
|
5. |
Disconnect the vapor hose connected with the canister from the CCV. |
6. |
Connect a vacuum pump to the nipple. |
7. |
Ground the CCV control line and apply battery voltage to the CCV power supply line. |
8. |
Apply vacuum and check the valve operation.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Lift the vehicle. |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the ventilation hose (B,C) from the fuel tank air filter and canister close valve. |
5. |
Remove the fuel tank air filter and canister close valve assembly (A) after removing the mounting nut (B). |
6. |
Release the lever (A), and then separate the canister close
valve (B) from the fuel tank air filter (C) after rotating it in the
direction of the arrow in the figure. |
Installation |
|
1. |
Installation is reverse of removal. |
Components and Components Location
Components
1. HECU module2. Front wheel speed sensor3. Rear wheel speed sensor4. Yaw rate & Lateral & Longitudinal G sensor5. Steering angle sensor6. ABS Warning lamp7. Parking brake/EBD ...
Interior care
Interior general precautions
Prevent chemicals such as perfume, cosmetic oil, sun cream, hand cleaner, and
air freshener from contacting the interior parts because they may cause damage or
discol ...