Inspection |
1. |
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
* Diagnostic procedure refer to DTC code. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the extension cover (A). |
3. |
Remove the shower duct (A). |
4. |
Loosen the screws and then remove the cluster ionizer (A). |
5. |
Installation is the reverse order of removal. |
Crankshaft Position Sensor (CKPS): Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...
Accelerator Position Sensor (APS): Schematic Diagrams
Circuit Diagram
...