Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Lift the vehicle with a jack. |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the ventilation hose (B) and vapor hose (C). |
5. |
Remove the fuel tank air filter and canister close valve assembly (A) after removing the installation nut (B). |
6. |
Release the lever (A), and then separate the canister close
valve (B) from the fuel tank air filter (C) after rotating it in the
direction of the arrow in the figure. |
7. |
Install a new fuel tank air filter in accordance with the reverse order.
|
Installation |
Fuel tank air filter bracket installation nut: 4.8 ~ 5.2 N.m (0.5 ~ 0.53 kgf.m, 3.54 ~ 3.84 lb-ft) |
Rear Driveshaft: Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque :
88.3 ~ 1 ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS): Specifications
Specifications
Direct control VFS[UD/B]
? Control type : Normal high type
Control Pressure kpa (kgf/cm?, psi)500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)Current value(mA)50 ~ 850 Internal resis ...