Self Diagnosis |
1. |
Self-diagnosis process |
2. |
How to read self-diagnostic code
After the display panel flickers three times every 0.5
second, the corresponding fault code flickers on the setup temperature
display panel every 0.5 second and will show two figures. Codes are
displayed in numerical format
Fault Code
|
3. |
Fault code display
|
4. |
If fault codes are displayed during the check, Inspect specific malfunctions causes by fault codes. |
5. |
Fail safe
|
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using the screwdriver, remove the cluster facia panel (A). |
3. |
Using the screwdriver, remove the crash pad garnish (A). |
4. |
Using the screwdriver, remove the center facia panel (A). |
5. |
Disconnect the center facia connectors (A). |
6. |
Loosen the control panel mounting screws and then remove the control panel (A). |
7. |
Disconnect the connectors and then remove the control panel (B). |
8. |
Installation is the reverse order of removal. |
Power Mosfet: Repair procedures
Inspection
1.
Ignition "ON"
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.
Specification
...
ETC (Electronic Throttle Control) System: Troubleshooting
Fail-Safe Mode
ItemFail-SafeETC MotorThrottle valve stuck at 5°TPSTPS 1 faultECM looks at TPS2TPS 2 faultECM looks at TPS1TPS 1,2 faultThrottle valve stuck at 5°APSAPS 1 faultECM looks at APS 2AP ...