Components |
Connector | Pin No | Function | Connector | Pin NO | Function |
Connector(A) | 1 | High | Connector(B) | 1 | Tail Lamp (ILL+) |
2 | Middle High | 2 | Battery | ||
3 | Middle Low | 3 | Mode Actuator (VENT) | ||
4 | - | 4 | Mode Actuator (DEF) | ||
5 | GND | 5 | Temp Actuator (COOL) | ||
6 | Low | 6 | Temp Actuator (WARM) | ||
| 7 | Intake Actuator (FRE) | |||
8 | Intake Actuator (REC) | ||||
9 | - | ||||
10 | Detent | ||||
11 | Mode Actuator (F/B) | ||||
12 | Temp Actuator (F/B) | ||||
13 | Intake Actuator (F/B) | ||||
14 | Blower Motor Common (-) | ||||
15 | Blower F/B | ||||
16 | Rheostat (ILL-) | ||||
17 | IG2 | ||||
18 | IG1 | ||||
19 | Can (HIGH) | ||||
20 | Can (LOW) | ||||
21 | HTD(Rear DEF IND.) | ||||
22 | ECV IN | ||||
23 | ECV OUT | ||||
24 | - | ||||
25 | Vref (+5V) | ||||
26 | Evaporator Sensor | ||||
27 | Ambient Sensor | ||||
28 | - | ||||
29 | - | ||||
30 | - | ||||
31 | Sensor GND | ||||
32 | GND |
Cruise Control Switch: Repair procedures
Removal and Installation
1.
Disconnect the battery (-) terminal.
Tightening torque:
Without battery sensor :
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
With battery sensor :
4.0 ~ 6.0N ...
Trailer towing
If you are considering towing with your vehicle, you should first check with
your country's Department of Motor Vehicles to determine their legal requirements.
Since laws vary the requirements ...