Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). |
3. |
Disconnect the knock sensor connector (A). |
4. |
Remove the installation bolt (B), and then remove the sensor from the cylinder block. |
Installation |
|
1. |
Installation is reverse of removal.
|
If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power,
or hear loud pinging or knocking, the engine will probably be too hot. If this happens,
you should:
1.Pull off the ...
Panoramic sunroof
If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof
with the sunroof control lever located on the overhead console (1).
The sunroof can only be opened, closed, or tilte ...