1.Turn the ignition switch to the ON position.
2.Turn the mode selection knob to the defrost position ().
3.Press the air intake control button at least 5 times within 3 seconds.
The indicator light in the air intake control button will blink 3 times with 0.5 second of interval. It indicates that the defogging logic is canceled or returned to the programmed status.
If the battery has been discharged or disconnected, it resets to the defog logic status.
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 1,000 km (600 miles) you may add to the performance, economy and life
of your vehicle.
Do not race the ...
Camshaft Position Sensor (CMPS): Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON’T remove the camshaft ...