The heating and cooling system can be controlled manually by pressing buttons or turning knob(s) other than the AUTO button. In this case, the system works sequentially according to the order of buttons or knob(s) selected.
1.Start the engine.
2.Set the mode to the desired position. For improving the effectiveness of heating
and cooling;
- Heating:
- Cooling:
3.Set the temperature control to the desired position.
4.Set the air intake control to the outside (fresh) air position.
5.Set the fan speed control to the desired speed.
6.If air conditioning is desired, turn the air conditioning system on.
Press the AUTO button in order to convert to full automatic control of the system.
Non-operational conditions of Back up warning system
The Back up warning system may not operate properly when:
1.Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.)
2.The sensor is covered with foreign ma ...
TPMS Receiver: Description and Operation
Description
1.
Mode
(1)
Virgin State
•
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
•
In this state, there is ...