Inspection |
1. |
Ignition "OFF” |
2. |
Disconnect the connector of mode control actuator. |
3. |
Verify that the mode control actuator operates to the defrost
mode when connecting 12V to the terminal 3and grounding terminal 4. |
4. |
Verify that the mode control actuator operates to the vent mode when connecting in the reverse.
|
5. |
Check the voltage between terminals 5 and 6.
It will feedback current position of actuator to controls. |
6. |
If the measured voltage is not specification, substitute with a known-good mode control actuator and check for proper operation. |
7. |
If the problem is corrected, replace the mode control actuator. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad left side cover (A). |
3. |
Remove the left extension cover(A). |
4. |
Remove the crash pad lower cover (A). |
5. |
Disconnect the diagnosis connector (A). |
6. |
Remove the reinforcing panel (A). |
7. |
Remove the left shower duct (A). |
8. |
Remove the BCM.
(Refer to BE group - "BCM") |
9. |
Disconnect the mode control actuator connector (A). |
10. |
Loosen the mounting screw and then remove the mode control actuator (B). |
11. |
Installation is the reverse order of removal. |
Do not install a child restraint on the front passenger’s seat.
Never place a rear-facing child restraint in the front passenger’s seat. If the
air bag deploys, it would impact the rear-facing child restraint, causing serious
or fatal injury.
In addition, d ...
Comfort mode
The steering effort becomes lighter in comfort mode.
For your safety, if you press the steering mode button to change the mode
while turning the steering wheel, the LCD display will change as ...