Removal |
1. |
Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. |
2. |
Remove the crash pad garnish. (Refer to the Body group- crash pad). |
3. |
Disconnect the passenger airbag connector and remove the PAB mounting bolt. |
4. |
Remove the crash pad. (Refer to the Body group- crash pad).
|
5. |
Remove the heater duct from the crash pad. |
6. |
Remove the mounting nuts(4EA) from the crash pad. Then remove the passenger airbag.
|
Installation |
1. |
Remove the ignition key from the vehicle. |
2. |
Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work. |
3. |
Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.
|
4. |
Install the heater duct to the crash pad. |
5. |
Install the crash pad. (Refer to the Body group- crash pad) |
6. |
Tighten the passenger airbag mounting bolt.
|
7. |
Connect the passenger airbag harness connector to the SRS main harness connector. |
8. |
Reinstall the crash pad garnish. (Refer to the Body group- crash pad) |
9. |
Reconnect the battery negative cable. |
10. |
After installing the passenger airbag (PAB), confirm proper system operation:
|
Transmitter precautions
The transmitter will not work if any of the following occurs:
The ignition key is in the ignition switch.
You exceed the operating distance limit (10 m [about 30 feet]).
The battery in the tra ...
Starter Relay: Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalContinuity30 - 87NO85 - 86Y ...