Inspection |
1. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
2. |
Remove the front door module.
(Refer to the BD group - "Front door") |
3. |
Disconnect the connectors from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily.
[Central Lock]
[Double Lock] |
1. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
2. |
Remove the rear door module.
(Refer to the BD group - "Rear door") |
3. |
Disconnect the connectors from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily.
[Central Lock]
[Double Lock] |
1. |
Remove the tailgate trim.
(Refer to the BD group - "Tailgate") |
2. |
Disconnect the 4P connector from the actuator. |
3. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
2. |
Remove the front door module.
(Refer to the BD group - "Front door") |
3. |
Disconnect the connectors from the actuator. |
4. |
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.
[Central Lock]
[Double Lock] |
1. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
2. |
Remove the rear door module.
(Refer to the BD group - "Rear door") |
3. |
Disconnect the connectors from the actuator. |
4. |
Check for continuity between the terminals in each switch position according to the table.
[Central Lock] |
1. |
Remove the tailgate trim.
(Refer to the BD group - "Tailgate") |
2. |
Disconnect the 4P connector from the actuator. |
3. |
Check for continuity between the terminals in each switch position according to the table. |
Components and Components Location
Components Location
1. Engine Control Module (ECM)2. Manifold Absolute Pressure Sensor (MAPS) #13. Intake Air Temperature Sensor (IATS)4. Manifold Absolute Pressure Sensor (MAPS) #25. Engine Coo ...
Front Impact Sensor (FIS): Description and Operation
Description
The front impact sensor (FIS) is installed in the Front End
Module (FEM). They are remote sensors that detect acceleration due to a
collision at its mounting location. The primary p ...