Inspection |
1. |
Ignition "ON" |
2. |
Manually operate the control switch and measure the voltage of blower motor. |
3. |
Select the control switch to raise voltage until high speed.
Specification
*AUTO COOLING : Auto speed (4.5V~B+)
*AUTO HEATING : Auto speed (4.5V~11.0V) |
4. |
If the measured voltage is not specification, substitute with a known-good power mosfet and check for proper operation. |
5. |
If the problem is corrected, replace the power mosfet. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after loosening the mounting screws. |
3. |
Installation is the reverse order of removal. |
Mode selection
The mode selection button controls the direction of the air flow through the
ventilation system.
The air flow outlet port is converted as follows:
Refer to the illustration in the “Manual clim ...
Vehicle certification label
The vehicle certification label attached on the driver’s side center pillar gives
the vehicle identification number (VIN). ...