Inspection |
1. |
With the power seat switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the power seat switch. |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the power seat recliner cover.
(Refer to the BD group - "Front seat") |
3. |
Remove the power seat control switch (A). |
Installation |
1. |
Install the power seat control switch after connecting the connector. |
2. |
Install the recliner cover and front power seat. |
Special Service Tools
Special Service Tools
Tool (Number and name)IllustrationUse09977-29000Disc & hub assembly bolt removerRemoval and installation of disc & hub assembly.
...
Fuel Tank Pressure Sensor (FTPS): Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition swit ...