Inspection |
1. |
Remove (-) negative battery terminal. |
2. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
3. |
Disconnect the connector from the motor.
(A : Safety, B : Standard) |
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor.
[Standard] |
5. |
Connect the terminal No. 2 and No. 3 to battery voltage (12V)
and check that the motor operates smoothly when connecting the
terminals below.
[Safety] |
1. |
Remove (-) negative battery terminal. |
2. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
3. |
Disconnect the connector from the motor. |
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor. |
Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance
for normal driving.
The tire label located on the driver's side center pillar gives the tire pressures
reco ...
ECOMINDER® indicator
Active ECO system
This indicator light illuminates:
When the Active ECO button is pressed the ECOMINDER® indicator (green) will illuminate
to show that the Active ECO is operating.
For more det ...