Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door") |
3. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch.
[Driver Auto Up/Down] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door") |
3. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch.
[General]
[Power Door Lock] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
3. |
Remove the rear power window switch module. |
4. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch.
[General] |
Headlight position
When the light switch is in the headlight position (2nd position), the head,
tail, license and instrument panel lights will turn ON.
The ignition switch must be in the ON position to turn on th ...
Good driving practices
Never take the vehicle out of gear and coast down a hill. This is extremely
hazardous. Always leave the vehicle in gear.
Don't "ride" the brakes. This can cause them to overheat ...