Replacement |
1. |
After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts.
|
2. |
Remove the center bearing bracket (A) mounting bolts.
|
3. |
After making a match mark on the flange yoke and transaxle companion, remove the propeller shaft mounting bolts.
|
4. |
Install in the reverse order of removal. |
Inspection |
1. |
Shift the transmission lever to Neutral. |
2. |
Raise the vehicle off the ground, and support it with safety stands in the proper locations. |
3. |
Check the center bearing for excessive play or rattle and
rubber for rent. If the center bearing has excessive play or rattle and
rubber has rent, replace the propeller shaft assembly. |
4. |
Check the CV joint boot for damage and deterioration. If the
boot is damaged or deteriored, replace the propeller shaft assembly. |
5. |
Check the CV joint for excessive play or rattle. If the CV
joint has excessive play or rattle, replace the propeller shaft
assembly. |
1. |
Install a dial indicator with its needle on the center of front propeller shaft or rear propeller shaft. |
2. |
Turn the propeller shaft slowly and check the runout. Repeat this procedure for the other propeller shaft.
|
3. |
If the runout on either propeller shaft exceeds the service limit, replace the propeller shaft assembly. |
Curtain Airbag (CAB) Module: Description and Operation
Description
Curtain airbags are installed inside the headliner (LH and
RH) and protect the driver and passenger from danger when side crash
occurs. The SRSCM determines deployment of curtain ai ...
ESC operation
ESC ON condition
When the ignition is turned ON, ESC and ESC OFF indicator lights illuminate
for approximately 3 seconds, then ESC is turned on.
Press the ESC OFF button for at least half a s ...