Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the RCV control solenoid valve connector. |
3. |
Measure resistance between the valve terminals 1 and 2. |
4. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the RCV control solenoid valve after disconnect the connector (A), bolt (B) and RCV hose (C). |
Installation |
|
1. |
Installation is the reverse order of removal.
|
Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are
cold. “Cold Tires” means the vehicle has not been driven for at least three hours
or driven less than 1.6 km (one mile ...
Alignment: Repair procedures
Front Wheel Alignment
When using a commercially available computerized wheel
alignment equipment to inspect the front wheel alignment, always
position the vehicle o ...