Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the center fascia panel.
(Refer to BE - "Audio") |
3. |
Remove the heater and A/C controller (A) after disconnecting the connector (B).
|
Installation |
1. |
Install the heater and A/C controller. |
2. |
Install the center fascia panel. |
Inspection |
1. |
The rear glass defogger switch inputs can be checked using the GDS. |
2. |
To check the input value of rear glass defogger switch, select option "BCM". |
3. |
Select option "Current Data". |
4. |
To check the input value of rear glass defogger switch in force mode, select option. |
Passive Occupant Detection System (PODS): Description and Operation
Description
The system is intended to classify the occupancy status of
the front passenger seat in a motor vehicle based upon the measured
force on the bottom seat cushion.
The system also com ...
Mode Control Actuator: Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control
actuator based on signal of A/C control unit. Pressing mode select ...