Kia Optima Manuals

Kia Sportage: Rear Seat Belt: Repair procedures - Seat Belt - Body (Interior and Exterior) - Kia Sportage SL Service & Repair ManualKia Sportage: Rear Seat Belt: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body (Interior and Exterior) / Seat Belt / Rear Seat Belt: Repair procedures

Replacement
Rear Seat Belt Replacement
   
•
When installing the belt, make sure not to damaged the retractor.
1.
Remove the following items first.
•
Rear seat assembly
(Refer to the BD group - "Rear Seat")
•
Front door scuff trim & Rear door scuff trim
(Refer to the BD group - "Interior Trim")
2.
Remove the clips and rear transverse trim (A).

3.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
After loosening the mounting bolts, then remove the rear seat mounting bracket (A).

5.
Using a screwdriver or remover, remove the lamp (A).
6.
Disconnect the connector (B).
7.
After loosening the mounting screws, then remove the luggage side trim (C).

8.
Disconnect the connector (A).

9.
After loosening the mounting bolt and screws, then remove the rear pillar trim (A).

10.
After loosening the mounting bolts, then remove the rear seat belt (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

11.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
•
Make sure the connectors are plugged in properly.
Rear Seat Belt Buckle Replacement
1.
Remove the rear seat.
(Refer to the BD group - "Rear Seat")
2.
After loosening the mounting bolt, then remove the rear seat belt buckle (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
[LH]

[RH]
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.
Installation is the reverse of removal.
Front Seat Belt: Repair procedures
Replacement Front Seat Belt Replacement     • When installing the belt, make sure not to damaged the pretensioner. 1. Remove the following items first : • ...

Body Electrical System
...

Other Information:

Yaw-rate and Lateral G Sensor: Repair procedures
Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the floor console upper cover. 3. Disconnect the yaw rate & lateral & Longitudinal G se ...

Seat height (for driver’s seat)
To change the height of the seat, push the lever upwards or downwards. To lower the seat cushion, push the lever down several times. To raise the seat cushion, pull the lever up several times. ...

Categories


Copyright © www.kispmanual.com 2014-2024