Inspection |
1. |
Remove the front door trim.
(Refer to the BD group - "Front door") |
2. |
Remove the front door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily.
[Central Lock] |
1. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
2. |
Remove the rear door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily.
[Central Lock] |
1. |
Remove the tailgate trim panel.
(Refer to the BD group - "Trunk lid") |
2. |
Disconnect the 4P connector from the actuator. |
3. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door") |
2. |
Remove the front door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table.
[Central Lock] |
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door") |
2. |
Remove the rear door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check for continuity between the terminals in each switch position according to the table.
[Central Lock] |
1. |
Remove the tailgate lid trim.
(Refer to the BD group - "Tailgate") |
2. |
Disconnect the 4P connector from the actuator. |
3. |
Check for continuity between the terminals in each switch position according to the table. |
1. |
Disconnect the connector from the hood switch (A). |
2. |
Check for continuity between the terminals and ground according to the table. |
1. |
Remove the burglar horn (A) after removing 1 bolt and disconnect the 2P connector from the burglar horn. |
2. |
Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2. |
3. |
The burglar horn should make a sound. If the burglar horn fails to make a sound replace it. |
Front Wheel Transfer Assembly: Repair procedures
Removal
It is not recommended to overhaul the transfer assembly
because a special three-dimensional measuring instrument is required to
determine the sizes of the t ...
Rear Door: Components and Components Location
Components
1. Rear door trim2. Rear door inside handle cap3. Rear door belt inside weatherstrip4. Rear door trim seal5. Rear door module6. Rear door panel7. Rear door belt weatherstrip8. Rear doo ...