Inspection |
1. |
Disconnect the vapor hose from the intake manifold and connect a vacuum pump to the nipple on the intake manifold.
· At Cold Engine [Engine Coolant Temperature < 60°C(140°F)]
|
2. |
Check the following points with applied vacuum at the purge control solenoid valve (PCSV).
· At Warmed Engine [Engine Coolant Temperature > 80°C(176°F)]
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Disconnect the PCSV connector (A). |
3. |
Disconnect the vapor hose (B) which is connected to the intake manifold from the PCSV. |
4. |
After connecting a vacuum pump to the nipple, apply vacuum. |
5. |
With the PCSV control line grounded, check the valve
operation with battery voltage applied to the PCSV(Open) and
removed(Closed).
|
6. |
Measure the coil resistance of the PCSV.
|
1. |
Select "Evap. Leakage Test". |
2. |
Proceed with the test according to the screen introductions. |
Active ECO operation
Active ECO helps improve fuel efficiency by controlling certain engine and transaxle
system operating parameters. Fuel efficiency depends on the driver's driving habit
and road condition.
...
Knock Sensor (KS): Schematic Diagrams
Circuit Diagram
...