Component Replacement After Deployment |
Before doing any SRS repairs, use the GDS Pro to check for
DTCs. Refer to the Diagnostic Trouble Code list for repairing of the
related DTCs. |
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Seat belt pretensioner(s) |
– |
Front impact sensors |
– |
SRS wiring harnesses |
– |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Side impact sensor(s) for the deployed side(s) |
– |
SRS wiring harnesses
|
– |
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off. |
Front Stabilizer Bar: Repair procedures
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub ...
Starter Relay: Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalContinuity30 - 87NO85 - 86Y ...