Kia Sportage: Room Lamp: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Lighting System / Room Lamp: Repair procedures
| Inspection |
| 1. |
Remove the room lamp assembly connector then check for continuity between terminals.
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver.
|
| 3. |
Loosen the fixing screws (2EA). |
| 4. |
Remove the room lamp assembly (A) after disconnecting the connector (B).
|
| Installation |
| 1. |
Install the room lamp assembly after connecting the lamp connector. |
| 2. |
Install the lamp lens after assembling the bulb. |
Turn Signal Lamp: Repair procedures
Removal
Rear Turn Signal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to BD group - "Rear Bumper")
3.
Disconnect the connector. Remove the rear ...
Overhead Console Lamp: Repair procedures
Inspection
Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
No.DescriptionNo.Descrip ...
Other Information:
Receiver-Drier: Repair procedures
Replacement
1.
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :
20~25N.m (2.0~2.5kgf.m, 14.5~18.2lb-ft)
2.
Remove the ...
Smart key precautions
If you lose your smart key, you will not be able to start the engine. Tow
the vehicle, if necessary, and contact an authorized Kia dealer.
A maximum of 2 smart keys can be registered to a sing ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright © www.kispmanual.com 2014-2024