Circuit Diagram - ESC(1) |
Circuit Diagram - ESC(2) |
Circuit Diagram - ESC(3) |
ESC connector input/output |
Connector Terminal | Specification | Remark | |
No | Description | ||
29 | IGNITION1(+) | High level of wake up voltage : 4.5V < V < 16.0V Low level of wake up voltage : V < 2.4V Max. current : I < 50mA | |
25 | POS. BATTERY 1.(SOLENOID) | Over voltage range : 17.0 ± 0.5V Operating voltage range : 10.0 ± 0.5V < V < 16.0 ± 0.5V Low voltage range : 7.0 ± 0.5V < V < 9.5 ± 0.5V Max. current : I < 40A Max. leakage current : I < 0.25mA | |
1 | POS. BATTERY 2.(MOTOR) | Operating voltage range: 10.0 ± 0.5V < V < 16.0 ± 0.5V Rush current : I < 110A Max current : I < 40A Max leakage current : I < 0.25mA | |
38 | GROUND | Rated current : I <550mA Max. current: I < 40A | |
13 | PUMP MOTOR GROUND | Rush current : I < 110A Max current : I < 40A | |
11 | SENSOR GROUND | Rated current : I <250mA | |
4 | SENSOR POWER | Max current Capability : I < 250mA Max voltage : V_BAT1 -0.8V | |
23 | BRAKE LIGHT SWITCH | Input voltage (Low) : V < 2V Input voltage (High) : V > 6V Max. Input current : I < 3mA | |
9 | BRAKE SWITCH | ||
22 | PARKING BRAKE SWITCH | Input voltage (Low) : V < 2V Input voltage (High) : V > 6V Max input current : I < 5mA | |
35 | CLUTCH SWITCH (M/T Only) | ||
28 | SENSOR FRONT RIGHT OUTPUT | External pull up resistance :1 K? < R Output duty : 50 ± 20% | |
17 | SENSOR REAT RIGHT OUTPUT | ||
10 | ESC ON/OFF SWITCH | Input voltage (Low) : V < 2V Input voltage (High) : V > 6V Max input current : I <3mA | |
37 | DBC SWITCH | ||
14 | CAN BUS LINE(LOW) | Max. Input current : I < 10mA | |
26 | CAN BUS LINE(HIGH) | ||
18 | SENSOR FRONT LEFT POWER | Output voltage : V_BAT1 -0.6V ~ V_BAT1 -1.1V Output current : Max 30mA | |
34 | SENSOR FRONT RIGHT POWER | ||
19 | SENSOR REAR LEFT POWER | ||
33 | SENSOR REAR RIGHT POWER | ||
31 | SENSOR FRONT LEFT SIGNAL | Input current LOW : 5.9 ~ 8.4mA Input current HIGH : 11.8 ~ 16.8mA Frequency range : 1 ~ 2500Hz Input duty : 50 ± 10% | Typ. 7mA Typ. 14mA |
21 | SENSOR FRONT RIGHT SIGNAL | ||
32 | SENSOR REAR LEFT SIGNAL | ||
20 | SENSOR REAR RIGHT SIGNAL | ||
12 | CAN SENSOR LINE (HIGH) | Max. input current : I < 10mA | |
24 | CAN SENSOR LINE (LOW) | ||
8 | BRAKE RELAY | Max. current : I < 180mA Max. Output low voltage : V < 1.2V | |
36 | RELAY STATE MONITORING | Input voltage (Low) : V < 2V Input voltage (High) : V > 6V Max Input current : I <10mA |
Tire traction
Tire traction can be reduced if you drive on worn tires, tires that are improperly
inflated or on slippery road surfaces. Tires should be replaced when tread wear
indicators appear. Slow down when ...
Fuel Pressure Control Valve: Description and Operation
Description
Fuel Pressure Regulator Valve is installed on the high
pressure fuel pump and controls fuel flow flowing into the injectors in
accordance with the ECM signal calculated based on var ...