Kia Optima Manuals

Kia Sportage: Seat Heater: Repair procedures - Seat Electrical - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Seat Heater: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Seat Electrical / Seat Heater: Repair procedures

Removal
1.
Remove the seat back cover and cushion cover.
(Refer to the BD group - "Front seat")
2.
Remove the driver / assist seat back heater (A) and cushion heater (B).

3.
Remove the cushion cover of rear seat.
(Refer to the BD group - "Rear seat")
4.
Remove the heater (A) of rear seat (LH) and the heater (B) of rear seat (RH).

Installation
1.
Install the driver / assist seat back and cushion heater.
(Refer to the BD group - "Front seat")
2.
Install the heater of rear seat (LH & RH).
(Refer to the BD group - "Rear seat")
Inspection
Driver / Assist Seat
1.
Check for continuity and measure the resistance between terminals as below.

No.
Description
No.
Description
1
Indicator
3
Low
2
Ground
4
High

Standard value
Cushion : 1.39? ± 10% (leather/fabric)
Back : 1.41? ± 10% (leather/fabric)
Set : 2.8? ± 10% (leather/fabric)
2.
Operate seat warmer after connecting the 4P connector, and then check the thermostat by measuring the temperature of seat surface.
Standard value
Cushion : 104 ± 3.6 °F(40 ± 2 °C) (LOW)
107.6 ± 3.6 °F(42 ± 2 °C) (HIGH)
Back : 114.8 ± 3.6 °F(46 ± 2 °C) (LOW),
125.6 ± 3.6 °F(52 ± 2 °C) (HIGH)
Rear Seat
1.
Check for continuity and measure the resistance between terminal 2 and 3.

No
Description
1
Indicator
2
Ground
3
Heater

Standard value
Cushion : 5.29? ± 10% (leather/fabric)
2.
Operate seat warmer after connecting the 4P connector, and then check the thermostat by measuring the temperature of seat surface.
Standard value
Cushion : 104 ± 3.6 °F (40 ± 2 °C)
Seat Heater: Components and Components Location
Component Location ...

Climate Seat: Components and Components Location
Components 1. Ventilation blower2. Ventilation ECU3. Ventilation seat switch4. Blower connector5. Heater connector6. Ventilation ECU connector ...

Other Information:

Camshaft: Repair procedures
Removal Timing chain cover removal is not required for this procedure.     • Use fender covers to avoid damaging painted surfaces. • To avoid damaging th ...

Description and Operation
Description Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module ...

Categories


Copyright © www.kispmanual.com 2014-2024