Kia Sportage: Shift Lever: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever: Repair procedures

Removal

1.	Remove the center console assembly. (Refer to "Interior(console)" in BD group.)

2.	Disconnect sports mode connector (A).

Remove the shift lever assembly (D).

(1)	Take off the clip (A) and then remove the shift cable (B).

(2)

Remove the bolts (C-4ea).

Tightening torque:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Installation

When installing, set room side shift lever and T/M side lever to "N" position.

1.	Install in the reverse order of removal.

Shift Lever: Components and Components Location

Components 1. Shift lever knob & boots assembly2. Shift lever assembly3. Shift cable assembly4. Cable retainer5. Shift cable retainer ...

Shift Cable: Components and Components Location

Components 1. Shift lever knob & boots assembly2. Shift lever assembly 3. Shift cable assembly4. Cable retainer ...

Other Information:

Limp home (override) procedure
When you turn the ignition switch to the ON position, if the immobilizer indicator () goes off after blinking 5 times, your transponder equipped in the ignition key is out of order. You cannot sta ...

3 Point rear center belt
To fasten the rear center belt 1.Extract the tongue plate from the hole on the belt assembly cover and slowly pull the tongue plates out from the retractor. 2.Insert the tongue plate (A) into ...

Kia Sportage: Shift Lever: Repair procedures

Shift Lever: Components and Components Location

Shift Cable: Components and Components Location

Other Information:

Categories