Before opening or closing the sunroof, open the roller blind (refer to the following page for instructions on how to use the roller blind).
To open or close the sunroof (manual slide feature), pull or push the sunroof control lever backward or forward to the first detent position.
Pulling the control lever downward also closes the sunroof.
To open the sunroof automatically:
Pull the sunroof control lever backward to the second detent position and then release it. The sunroof will slide open all the way automatically.
To stop the sunroof sliding at any point, pull or push the sunroof control lever momentarily.
To close the sunroof automatically:
Push the sunroof control lever forward to the second detent position and then release it. The sunroof will automatically close all the way.
To stop the sunroof sliding at any point, pull or push the sunroof control lever momentarily.
Rain Sensor: Repair procedures
Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are
controlled by the rain sensor inpu ...
Schematic Diagrams
Circuit Diagram - ESC(1)
Circuit Diagram - ESC(2)
Circuit Diagram - ESC(3)
ESC connector input/output
Connector TerminalSpecificationRemarkNoDescription29IGNITION1(+)High level of wake up vol ...