Removal |
1. |
Remove the seat back cover and cushion cover.
(Refer to the BD group - "Front seat") |
2. |
Remove the driver / assist seat back heater (A) and cushion heater (B). |
3. |
Remove the cushion cover of rear seat.
(Refer to the BD group - "Rear seat") |
4. |
Remove the heater (A) of rear seat (LH) and the heater (B) of rear seat (RH). |
Installation |
1. |
Install the driver / assist seat back and cushion heater.
(Refer to the BD group - "Front seat") |
2. |
Install the heater of rear seat (LH & RH).
(Refer to the BD group - "Rear seat") |
Inspection |
1. |
Check for continuity and measure the resistance between terminals as below.
|
2. |
Operate seat warmer after connecting the 4P connector, and
then check the thermostat by measuring the temperature of seat surface.
|
1. |
Check for continuity and measure the resistance between terminal 2 and 3.
|
2. |
Operate seat warmer after connecting the 4P connector, and
then check the thermostat by measuring the temperature of seat surface.
|
Front Lower Arm: Repair procedures
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 07.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bo ...
Injector: Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the injector terminals 1 and 2.
4.
Check that the resistance is within t ...