Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door") |
3. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch.
[Driver Auto Up/Down] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim and power window switch.
(Refer to the BD group - "Front door") |
3. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch.
[General]
[Power Door Lock] |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear door trim.
(Refer to the BD group - "Rear door") |
3. |
Remove the rear power window switch module. |
4. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is not
normal, replace the switch.
[General] |
Repair procedures
Starter Circuit Troubleshooting
The battery must be in good condition and fully charged.
1.
Disconnect the fuel pump relay (A) in the fuse box.
2.
With the shif ...
Heater & A/C Control Unit(Manual): Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using the screwdriver, remove the cluster facia panel (A).
3.
Using the screwdriver, remove the crash pad garnish (A).
4. ...