Kia Sportage: Windshield Deicer: Repair procedures
Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Windshield Deicer / Windshield Deicer: Repair procedures
| Inspection |
| 1. |
Remove the cowl top cover.
(Refer to the wiper) |
| 2. |
Disconnect the windshield deicer connector (A) from the wiper motor linkage.
|
| 3. |
Check for continuity between the terminals of deicer lines.
|
| 4. |
Turn the ignition switch ON and the windshield deicer switch
ON, then measure the voltage between the terminals of harness side
deicer connector.
|
Description and Operation
Description
Windshield deicer system prevent windshield wiper from
freezing in the winter season. It consists of deicer in the lower part
of windshield, switch and relay.
Body control module ...
Windshield Deicer Switch: Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to BE - "Audio")
3.
Remove the heater and A/C controller (A) after disconnecting the con ...
Other Information:
Ambient Sensor: Description and Operation
Description
1.
The ambient temperature sensor is located at the front of the
condenser and detects ambient air temperature. It is a negative type
thermistor; resistance will increase with lowe ...
Securing a child restraint seat with tether anchor system
Child restraint hook holders are located on the back of the rear seatbacks.
1.Route the child restraint seat strap over the seatback.
For vehicles with adjustable headrests, route the tether str ...
Categories
- Home
- Kia Sportage QL (2015-2019) Owners Manual
- Kia Sportage QL (2015-2019) Service Manual
- Kia Sportage SL 2010-2016 Owners Manual
- Kia Sportage SL 2010-2016 Service Manual
Copyright © www.kispmanual.com 2014-2024