Remove the steering column upper and lower shrouds (A) after removing 3 screws.
Take care not to damage and scratch the shrouds and its related parts.
Take care not to damage the hook when removing the upper and lower shrouds.
3.
Disconnect the light switch connector (A) and the wiper switch connector (B).
4.
Remove the wiper switch (A) by pushing the lock pin (B).
When removing the wiper & washer switch only, release the lock of wiper switch without removing the steering wheel.
5.
Remove the steering wheel.
(Refer to ST group - "Steering column and shaft")
6.
Remove the clock spring.
(Refer to RT group - "Airbag module")
7.
Remove the multifunction switch assembly (A) after loosening screws (2EA).
Installation
1.
Install the multifunction switch after connecting the connector.
2.
Install the clock spring and steering wheel.
3.
Install the steering column upper and lower shrouds.
Inspection
Check for continuity between the terminals while operating
the wiper and washer switch. If it is not normal condition, replace
wiper and washer switch.
Component Location
1. Cap2. Nut3. Wiper arm & blade4. Clip5. Cowl top cover6. Bolt7. Wiper motor & linkage assembly8. Wiper motor connector
...
Other Information:
Jack and tools
The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment.
Pull up the luggage box cover to reach this equipment.
(1) Jack handle
(2) Jack
(3) Wheel lug nut wrench
Jacki ...
Water pump: Repair procedures
Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to drain with speed.
2.
Remove the drive belt (A) after turning the drive belt ten ...