Inspection |
1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with washer fluid.
|
2. |
Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively. |
3. |
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles. |
4. |
If they are abnormal, replace the washer motor.
|
Removal |
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front bumper cover.
(Refer to the BD group - "Front bumper") |
3. |
Remove the front washer motor connector (A). |
4. |
Remove the rear washer motor connector (A). |
5. |
Remove the washer hose, the front washer motor and the rear washer motor. |
6. |
Remove the washer reservoir (A) after removing 3 bolts. |
Installation |
1. |
Reassemble the washer reservoir.
|
2. |
Connect the washer motor connectors and washer hoses. |
3. |
Install the front and rear washer motor. |
4. |
Install the front and rear washer nozzle.
|
5. |
Install the front bumper cover. |
6. |
Refill the washer fluid. |
Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling” while the vehicle is in motion,
store them ...
Knock Sensor (KS): Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
3.
Disconnect the ...