Check for continuity between the terminals while operating
the wiper and washer switch. If it is not normal condition, replace
wiper and washer switch.
Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
3.
Check that ...
Inspection
1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
Before filling the reservoir tank with water, check the
fil ...
Other Information:
Parking brake & brake fluid warning light
Parking brake warning
This light is illuminated when the parking brake is applied with the ignition
switch in the START or ON position. The warning light should go off after a few
seconds when ...
Under Body: Body Repair
Projected Dimensions
Front side member tooling hole (O6.5)Side cover mounting hole (O8)Front sub frame mounting hole (O17)Front sub frame mounting hole (O18)Front side member rear extension tooli ...