Inspection |
1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
2. |
Remove the front bumper cover.
(Refer to the BD group - "Front bumper") |
3. |
Connect positive (+) and negative (-) battery cables to
terminals 2 and 1 respectively to see that the washer motor runs and
water is pumped. |
4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
|
Fuel Filler Cap: Description and Operation
Description
A ratchet tightening device on the threaded fuel filler cap
reduces the chances of incorrect installation, which seals the fuel
filler. After the gasket on the fuel filler cap and t ...
Components and Components Location
Component Location
1. Driver power window main switch2. Passenger window switch3. Front window motor4. Rear window motor5. Rear window switch
...