Kia Sportage: Auto Light Sensor: Repair procedures - Auto Lighting Control System - Body Electrical System - Kia Sportage SL Service & Repair ManualKia Sportage: Auto Light Sensor: Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor: Repair procedures

Inspection
In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor''s input.
The auto light control doesn''t work if the pin sunlight supply (5V regulated power from Ignition 1 power to sunlight sensor) is in short circuit with the ground.
If IGN1 ON, The IPM monitors the range of this supply and raises up a failure as soon as the supply’s voltage is out of range. Then this failure occurs and as long as this is present, the head lamp must be turned on without taking care about the sunlight level provided by the sensor.
This is designed to prevent any head lamp cut off when the failure occurs during the night.

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the photo & auto light sensor (A) from crash pad upper side by using a flat-up screwdriver.

3.
Remove the auto light sensor connector.
Installation
1.
Reconnect the auto light sensor connector.
2.
Install the auto light sensor.
Description and Operation
Description This function describes the following features – Input detection by Auto Light Sensor. – Generate Auto Light Out Status data. – Send Auto Light Out Status. ...

Immobilizer System
...

Other Information:

Front Impact Sensor (FIS): Repair procedures
Removal     • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impac ...

Input Speed Sensor: Repair procedures
Inspection 1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. Removal 1. Remove the valve body assembly. (R ...

Categories


Copyright © www.kispmanual.com 2014-2024