Inspection |
1. |
Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. |
2. |
Check for continuity between the terminals. |
3. |
If continuity is not specified, replace the switch. |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the steering column upper and lower shrouds.
(Refer to the ST group - "Steering column") |
3. |
Remove the ignition switch (A) after disconnecting the 6P connector (B). |
4. |
Remove the key warning and immobilizer connector (A). |
5. |
Remove the key illumination cover. |
6. |
If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder after pushing lock pin (B) with key ACC. |
Installation |
1. |
Install the key lock cylinder. |
2. |
Install the illumination cover. |
3. |
Install the key warning and immobilizer connector. |
4. |
Install the ignition switch. |
5. |
Install the steering column shrouds and crash pad lower panel. |
Line Pressure Control Solenoid Valve: Specifications
Specifications
Direct control VFS[LINE Pressure]
? Control type : Normal high type
Control Pressure kpa (kgf/cm?, psi)500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)Current value(mA)50 ~ 850 Inter ...
Components and Components Location
Component Location (1)
1. Head lamp(Low)2. Head lamp(High)3. DRL & position LED4. Front turn signal lamp5. Front fog lamp6. Door mirror turn signal lamp (LED)7. Overhead lamp8. Room lamp9. Va ...