Components |
Connector | Pin No | Function | Connector | Pin NO | Function |
Connector(A) | 1 | High | Connector(B) | 1 | Tail Lamp (ILL+) |
2 | Middle High | 2 | Battery | ||
3 | Middle Low | 3 | Mode Actuator (VENT) | ||
4 | - | 4 | Mode Actuator (DEF) | ||
5 | GND | 5 | Temp Actuator (COOL) | ||
6 | Low | 6 | Temp Actuator (WARM) | ||
| 7 | Intake Actuator (FRE) | |||
8 | Intake Actuator (REC) | ||||
9 | - | ||||
10 | Detent | ||||
11 | Mode Actuator (F/B) | ||||
12 | Temp Actuator (F/B) | ||||
13 | Intake Actuator (F/B) | ||||
14 | Blower Motor Common (-) | ||||
15 | Blower F/B | ||||
16 | Rheostat (ILL-) | ||||
17 | IG2 | ||||
18 | IG1 | ||||
19 | Can (HIGH) | ||||
20 | Can (LOW) | ||||
21 | HTD(Rear DEF IND.) | ||||
22 | ECV IN | ||||
23 | ECV OUT | ||||
24 | - | ||||
25 | Vref (+5V) | ||||
26 | Evaporator Sensor | ||||
27 | Ambient Sensor | ||||
28 | - | ||||
29 | - | ||||
30 | - | ||||
31 | Sensor GND | ||||
32 | GND |
Starter: Repair procedures
Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal (A).
Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
3.
Remove the ...
Alternator: Components and Components Location
Components
1. Pulley2. Front bracket3. Front bearing4. Rotor 5. Rear bearing 6. Rear bracket7. Through bolt8. Regulator assembly9. Regulator bolt10. Rear cover
...