Self Diagnosis |
1. |
Self-diagnosis process |
2. |
How to read self-diagnostic code
After the display panel flickers three times every 0.5
second, the corresponding fault code flickers on the setup temperature
display panel every 0.5 second and will show two figures. Codes are
displayed in numerical format
Fault Code
|
3. |
Fault code display
|
4. |
If fault codes are displayed during the check, Inspect specific malfunctions causes by fault codes. |
5. |
Fail safe
|
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Using the screwdriver, remove the cluster facia panel (A). |
3. |
Using the screwdriver, remove the crash pad garnish (A). |
4. |
Using the screwdriver, remove the center facia panel (A). |
5. |
Disconnect the center facia connectors (A). |
6. |
Loosen the control panel mounting screws and then remove the control panel (A). |
7. |
Disconnect the connectors and then remove the control panel (B). |
8. |
Installation is the reverse order of removal. |
Anchor Pretensioner: Description and Operation
Description
Anchor pretensioner operates as well as belt Pretensioner at
the same time If it gets into its deploy condition after a collision. It
is located at near anchor on front seat and it ...
Lighting control
The light switch has a Headlight and a Parking light position. To operate the
lights, turn the knob at the end of the control lever to one of the following positions:
(1) OFF position
(2) Parkin ...