Knocking is a phenomenon characterized by undesirable
vibration and noise and can cause engine damage. Knock Sensor (KS) is
installed on the cylinder block and senses engine knocking.
When knocking occurs, the vibration from the cylinder block
is applied as pressure to the piezoelectric element. When a knock
occurs, the sensor produces voltage signal. The ECM retards the ignition
timing when knocking occurs. If the knocking disappears after retarding
the ignition timing, the ECM will advance the ignition timing. This
sequential control can improve engine power, torque and fuel economy.
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON’T remove the camshaft ...
ACC(Accessory)
Orange indicator
• With automatic transaxle
Press the ENGINE START/STOP button while it is in the OFF position without depressing
the brake pedal.
If the ENGINE START/STOP button is in the ACC ...
Filler-Neck Assembly: Repair procedures
Removal
1.
Remove the rear-LH wheel, tire, and the inner wheel house.
2.
Disconnect the fuel filler hose (A) and the ventilation hose (B).
3.
Open the fuel filler door and unfasten the fil ...