Kia Sportage: Knock Sensor (KS): Repair procedures

Third generation SL (2010–2016) / Kia Sportage SL Service & Repair Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS): Repair procedures

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).

3.	Disconnect the knock sensor connector (A).

4.	Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

Installation is reverse of removal.

Knock sensor installation bolt:

18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

Knock Sensor (KS): Schematic Diagrams

Circuit Diagram ...

Heated Oxygen Sensor (HO2S): Description and Operation

Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in ...

Other Information:

Repair procedures
On-vehicle Inspection Spark Test 1. Disconnect the ignition coil connectors (A). 2. Remove the ignition coils (A). 3. Using a spark plug socket, remove the spark plug. 4. Install th ...

Specifications
Specifications Ignition System ItemsSpecificationsIgnition coilPrimary resistance0.62 ± 10 % (?)Secondary resistance7.0 ± 15 % (k?)Spark plugsTypeZXU20HCR8Gap0.7 ~0.8 mm (0.0276 ~ 0.0315 in.) ...

Kia Sportage: Knock Sensor (KS): Repair procedures

Knock Sensor (KS): Schematic Diagrams

Heated Oxygen Sensor (HO2S): Description and Operation

Other Information:

Categories