Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the HO2S connector. |
3. |
Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. |
4. |
Measure resistance between the HO2S terminals 3 and 4 [B1/S2]. |
5. |
Check that the resistance is within the specification.
|
Removal |
[Bank 1 / Sensor 1] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Disconnect the connector (A), and then remove the sensor (B).
|
[Bank 1 / Sensor 2] |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the console side cover (A). |
3. |
Disconnect the connector (A), and then remove the sensor (B).
|
Installation |
|
|
1. |
Installation is reverse of removal.
|
Accelerator Position Sensor (APS): Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the
accelerator pedal module and detects the rotation angle of the
accelerator pedal. The APS is one of the most important sensors ...
Special Service Tools
Special Tools
Tool (Number and name)IllustrationUse09793-21000Door hinge adjusting wrenchAdjustment, removal and installation of the door hinge09800-21000Ornament removerTrim removal09853-31000H ...