Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in the sensor converts the
pressure to voltage signal. By using this signal, the ECM can control
correct injection amount and timing and adjusts the fuel pressure with
the fuel pressure regulator valve if the target pressure and the actual
pressure calculated by the RPS output signal are different.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 4 and 5 [B1/S1].
4.
Measure resistance between the HO2S t ...
Seatback pocket
WARNING - Seatback pocket
Do not put heavy or sharp objects in the seatback pocket. An occupant could
contact such objects in a crash. Heavy objects in the front passenger seatback could
al ...
Tail Gate: Repair procedures
Replacement
Tail Gate Trim Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related ...