Inspection |
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Measure the output voltage of the RPS at idle and various engine speed.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Release the residual pressure in fuel line (Refer to the
Fuel Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line").
|
3. |
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group). |
4. |
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe. |
Installation |
|
1. |
Installation is reverse of removal.
|
26 Brake Control Solenoid Valve(26/B_VFS): Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct (A).
3.
Remove the air cleaner assembly.
(1)
Disconnect the breather hose (A) and brake booster intensifier hose.
(2)
...
Back up warning system
The Back up warning system assists the driver during backward movement of the
vehicle by chiming if any object is sensed within a distance of 120 cm (47 in.)
behind the vehicle.
This system is ...