Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the OTS connector. |
3. |
Remove the OTS. |
4. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the OTS terminals 1 and 2. |
5. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the OTS connector (A). |
3. |
Remove the OTS. |
Installation |
1. |
Installation is reverse of removal. |
Maintenance services
You should exercise the utmost care to prevent damage to your vehicle and injury
to yourself whenever performing any maintenance or inspection procedures.
Should you have any doubts concerning the ...
Schematic Diagrams
Circuit Diagram - ESC(1)
Circuit Diagram - ESC(2)
Circuit Diagram - ESC(3)
ESC connector input/output
Connector TerminalSpecificationRemarkNoDescription29IGNITION1(+)High level of wake up vol ...