Accelerator Position Sensor (APS) is installed on the
accelerator pedal module and detects the rotation angle of the
accelerator pedal. The APS is one of the most important sensors in
engine control system, so it consists of the two sensors which adapt
individual sensor power and ground line. The second sensor monitors the
first sensor and its output voltage is half of the first one. If the
ratio of the sensor 1 and 2 is out of the range (approximately 1/2), the
diagnostic system judges that it is abnormal.
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OTS connector.
3.
Remove the OTS.
4.
After immersing the thermistor of the sensor into engine coolant, measure resistance ...
Front seat heater
Type A
The seat heater is provided to warm the front seats during cold weather. With
the ignition switch in the ON position, push either of the switches to warm the
driver's seat or the fro ...
Rocking the vehicle
If it is necessary to rock the vehicle to free it from snow, sand, or mud, first
turn the steering wheel right and left to clear the area around your front wheels.
Then, shift back and forth betwe ...