Inspection |
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Measure the output voltage of the FTPS.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the rear seat (Refer to "Seat" in BD group). |
3. |
Remove the fuel pump service cover (A). |
4. |
Disconnect the fuel tank pressure sensor connector (A). |
5. |
Remove the fuel tank pressure sensor after releasing the hooks vertically. |
Installation |
|
|
1. |
Installation is reverse of removal. |
To cancel cruise control, do one of the following
Press the brake pedal.
Press the clutch pedal with a manual transaxle.
Shift into N (Neutral) with an automatic transaxle.
Push the CANCEL switch located on the steering wheel.
Decrease t ...
Floor mat anchor(s)
When using a floor mat on the floor carpet, make sure it attaches to the floor
mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.
The following must be observed when in ...