Based on information from various sensors, the ECM can
calculate the fuel amount to be injected. The fuel injector is a
solenoid-operated valve and the fuel injection amount is controlled by
length of injection time. The ECM controls each injector by grounding
the control circuit. When the ECM energizes the injector by grounding
the control circuit, the circuit voltage should be low (theoretically
0V) and the fuel is injected. When the ECM de-energizes the injector by
opening control circuit, the fuel injector is closed and circuit voltage
should momentarily peak, and then settle at system voltage.
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition swit ...
Front seat adjustment - power
The front seat can be adjusted by using the control switches located on the outside
of the seat cushion. Before driving, adjust the seat to the proper position so you
can easily control the steeri ...
Repair procedures
Inspection
[System Inspection]
1.
Disconnect the vapor hose from the intake manifold and connect a vacuum pump to the nipple on the intake manifold.
· At Cold Engine [Engine Coolant Temperatur ...