Service Adjustment Procedure |
Oil level Check |
When checking the oil level, be careful not to enter dust, foreign matters, etc. from fill hole.
|
1. |
Remove the eyebolt (A).
|
2. |
Add ATF SP-IV 700cc to the ATF injection hole. |
3. |
Start the engine. (Don’t step on brake and accelerator simultaneously. |
4. |
Confirm that the temperature of the Automatic Transaxle(AT) oil temperature sensor is 50 ~ 60°C(122 ~ 140°F) with the GDS. |
5. |
Shift the select lever slowly from “P” to “D”, then “D” to “P” and repeat one more at idle.
|
6. |
Lift the vehicle, then remove the oil level plug (A) from the valve body cover.
|
7. |
If the oil flows out of the overflow plug in thin steady stream, the oil level is correct.
Then finish the procedure and tighten the oil plug.
|
8. |
Lower the vehicle with the lift and then tighten the eyebolt. |
Replacement |
1. |
Remove the drain plug (A) and drain the ATF totally. Reinstall the drain plug.
|
2. |
Fill the oil about 5 liters through eyebolt. |
3. |
Check the oil level.
(Refer to Hydraulic System - "Fluid") |
Front Strut Assembly: Components and Components Location
Components
1. Strut assembly2. Insulator3. Bearing4. Spring upper pad5. Spring6. Dust cover7. Spring lower pad
...
To increase cruise control set speed
Follow either of these procedures:
Push the RES + switch and hold it. Your vehicle will accelerate. Release
the switch at the speed you want.
Push the RES + switch and release it immediatel ...